Dutton-Lainson Company

Combines the safety of a brake winch with the convenience of being able to freewheel when needed. When freewheel lever is engaged, cable can be pulled off manually, to save time. When lever is disengaged, braking mechanism takes effect to lock load in place, even when handle is released. 800 lb capacity, zinc TUFFPLATE finish. 50 lb minimum load required for winch to operate properly. Handle included.

Wiring harness fits 12 volt DC StrongArm models SA5000, SA7000, SA9000 and SA12000. 25 foot power cable, 8 foot ground cable, #8 wire with switch and 70 amp circuit breaker.

20 foot winch strap with hook, with breaking strength of 2600 lbs, for winches up to 1700 lbs (strap rating must be 150% of winch rating). 2 inch width, includes mounting hardware.

CSA APPROVED 120 Volt Electric Winch has 10 foot, 3-wire grounded power cord. 1200 lb capacity. Power in, power out, controlled freewheeling clutch, and automatic brake. Comes loaded with 20 ft of 3/16 aircraft cable. Emergency crank handle also included in case of power loss. Similar to SA5000AC, but with additional features required in Canada. NOTE: THIS WINCH IS BUILT FOR HORIZONTAL PULLING. FOR VERTICAL LIFTING APPLICATIONS, WE RECOMMEND ORDERING A WINCH WITH NO CLUTCH INSTALLED. PRICE IS THE SAME. NOTE: MAXIMUM RUN TIME 3 MINUTES. SEE OWNERS MANUAL FOR MORE DETAILS.

Similar to 24975, but NO CLUTCH, so no freewheeling capability. Suitable for short-distance vertical lifting applications not involving people, or loads where people could be present. NOTE: MAXIMUM RUN TIME 3 MINUTES. SEE OWNERS MANUAL FOR MORE DETAILS.

Brake winch safety and rugged construction at a more economical price. Raise and lower loads with minimal effort, with load locked in place, even when handle is released. 1200 lb capacity, zinc TUFFPLATE finish. 50 lb minimum load required for winch to operate properly. Handle included.

Replaces or repairs switch end of 6362 wiring harness on SA5000, SA7000, SA9000, and SA12000 StrongArm 12 volt electric winches. Includes switch and short lead wires with heavy butt splice connectors to attach to existing positive and negative wire harness leads for easy installation.