Dutton-Lainson Company

Brake winch safety and rugged construction at a more economical price. Raise and lower loads with minimal effort, with load locked in place, even when handle is released. 1200 lb capacity, powder coated copper bronze finish. 50 lb minimum load required for winch to operate properly. Handle included.

Replacement wheels for model 6800 jack. Includes two 6 inch diameter wheels, axle bolt and nut.

CSA APPROVED 120 Volt Electric Winch with factory-installed remote control (handheld pendant switch with 10 ft cord) has 10 foot, 3-wire grounded power cord. 1200 lb capacity. Power in, power out, controlled freewheeling clutch, and automatic brake. Comes loaded with 20 ft of 3/16 inch aircraft cable. Emergency crank handle also included in case of power loss. Similar to SA5015AC, but with additional features REQUIRED IN CANADA. NOTE: THIS WINCH IS BUILT FOR HORIZONTAL PULLING. FOR VERTICAL LIFTING APPLICATIONS, WE RECOMMEND ORDERING A WINCH WITH NO CLUTCH INSTALLED. PRICE IS THE SAME. NOTE: MAXIMUM RUN TIME 3 MINUTES. SEE OWNERS MANUAL FOR MORE DETAILS.

Similar to 25542, but NO CLUTCH, so no freewheeling capability. Suitable for short-distance vertical lifting applications not involving people, or loads over where people could be present. NOTE: MAXIMUM RUN TIME 3 MINUTES. SEE OWNERS MANUAL FOR MORE DETAILS.

Combines the safety of a brake winch with the convenience of being able to freewheel when needed. When freewheel lever is engaged, cable can be pulled off manually to save time. When lever is disengaged, braking mechanism takes effect to lock load in place, even when handle is released. 1200 lb capacity, zinc TUFFPLATE finish. 50 lb minimum load required for winch to operate properly. Handle included.

1100 lb winch for horizontal pulling applications. High carbon steel gears, permanently lubricated bearings, ergonomic handle grip. Zinc TUFFPLATE finish. Handle included.

Roller bunk bracket, for mounting galvanized models 6387/6388. Zinc TUFFPLATE finish. Sold and priced individually. 4 needed to mount a pair of roller bunks. Allows bunks to be adjusted vertically and angled to cradle the boat hull.

1-1/16 x 3/4 inch spindle O.D., 1.781 outer hub I.D. Cone nbr LM11949/L44649, cup nbr LM11910/L44610. Includes 2 bearings with races, 1 grease seal, and cotter pin. IMPORTED.