Dutton-Lainson Company

2000 lb Worm Gear Winch with 5/8 inch hex drive. Comes with mating handle that can be removed easily without tools. Also allows the winch to be operated with a power drill hooked directly to the drive shaft. Cable capacities: 7/32 in (up to 82 ft)... 1/4 in (up to 59 ft)... 9/32 in (up to 49 ft). Smaller or larger cable diameters are not recommended.

4-foot roller bunks (pair) attach directly to vertically-mounted 2 x 4 bunk boards, or can be mounted with 6356 brackets (sold separately). A quick, easy and inexpensive way to upgrade bunk trailers to rollers. 14 gauge steel, black powder coated finish, rubber rollers. For boats weighing up to 2500 lbs. The advantage of this style of roller bunks is that each set of rollers has some wobble capabilities (up to roughly 10 degrees), providing some self-alignment with the boat hull. The rated capacity is based on having good contact with all of the rollers, and a reasonably even distribution of weight on the rollers. Rollers must be in contact with straight sections of the boat hull. It is critical to avoid a very large load on the first set of rollers during the unloading and loading process. The boat should float at least part way onto the trailer before contacting rollers, so that all of its weight is not concentrated on the first set of rollers. A concentrated load can crush a single set of rollers, with the potential for damage to the boat hull.

3/4 inch spindle O.D., 1.781 outer hub I.D. Cone nbr LM11949, cup nbr LM11910. Includes 2 bearings with races, 1 grease seal and cotter pin. IMPORTED.

Heavy duty Class 1 welded link chains for trailers up to 2000 lbs. Zinc plated finish to resist rust, with heavy steel hook and safety clip that latches to keep chains attached to tow vehicle. Chain size 3/16 inch, mount with 3/8 inch bolts. Meets SAE and V-5 standards. Two 18-inch chains per package. NOTE: Do not mount chains to trailer tongue with the same bolts used to mount coupler. Cross safety chains under coupling, allowing only enough slack for turns.

Top wind handle with bolt and nut. For use with D-L tongue jacks only.

Model 5E anchor, galvanized finish. Recommended for boats under 15 feet in length.

Class 1 (2000 lb) coupler with pin & chain, fits 2 inch tongue. Zinc TUFFPLATE finish.

Dynamic brake remote control for 120 volt AC StrongArm electric winches. Dual switch controls in/out and off/run. Provides dynamic braking function to supplement mechanical brake on winch, bringing load to an immediate halt without coasting. 10 foot cord length.